Overview
The Pro Comp Alloy Wheels 4.5-inch two-piece push-through cap, part number 7450141, is a replacement center cap for the 6066 wheel. The title identifies it as a push-through design, which pushes into the wheel center without screws.
The cap is 4.5 inches in diameter and is made for the 6066 wheel. Confirm the wheel model and center bore before ordering, since the fit depends on both.
Key features
- Two-piece push-through design
- 4.5-inch diameter
- Made for the 6066 wheel
Choosing a push-through cap
A push-through cap is pressed through the center bore from the front and held by its inner section, which makes the inside dimension as important as the face size. Before buying, measure the bore on your wheel and compare it with the 4.5-inch diameter. A cap that is too tight can crack under pressure, while one that is too loose will rattle and eventually fall out on rough ground.
Two-piece designs often need the halves aligned before the cap is fully seated, so check the fit once it is in place. Keep the removed cap and any small fasteners together, and store the spare dry to prevent corrosion on the inner section. If the wheel center has been struck by a rock or curb, inspect the bore for dents that could stop a new cap from seating.
Specifications
| Brand | Pro Comp Alloy Wheels |
|---|---|
| Part number | 7450141 |
| UPC | 70000411381 |
| Diameter | 4.5 inches |
| Design | Two-piece, push-through |
| Wheel | 6066 |
Vehicle fitment
No vehicle is named for this cap. It is tied to the 6066 wheel, so match the 4.5-inch size to that wheel’s center bore.
What’s included
One center cap is included. Count the pieces on arrival against the two-piece design before fitting it.









