Overview
The Go Rhino 4412B is a black powdercoat 4000 Series side step for the 1995–1998 Toyota T100 in Base, DLX, DX and SR5 trims. It bolts beneath the doors to create a lower entry point.
A smooth 90 degree bend and non-slip pads make a clean stepping surface. Custom designed for each application, the step is supplied with brackets and carries a 5 Year Warranty.
Key features
- Black powdercoat finish
- Smooth 90 degree bend
- Non-slip pads for entry and exit
- Brand notes say the install is bolt-on and typically drill-free
- Brackets in the kit
- Custom designed for each application
- 5 Year Warranty
Choosing a side step
A side step gives a lower entry point, which matters most on trucks with tall rocker panels and higher cabs. When choosing one, think about how you climb in and out daily, how much clearance the bar leaves over rough ground, and whether the mounts will sit square against the frame. A bar that sits lower gives easier entry but can catch on rocks sooner.
Side steps also take load from passengers and gear, so the brackets and bolts carry real stress. Check the fasteners after the first few drives and again after any hard off-road day. Keep the pads clean so grit does not wear them down. Good steps pair well with rocker protection if the bar will see frequent contact.
Specifications
| Brand | Go Rhino |
|---|---|
| Part number | 4412B |
| UPC | 619632025192 |
| Product line | 4000 Series SideSteps |
| Finish | Black Powdercoat |
| Warranty | 5 Year Warranty |
Vehicle fitment
It fits the 1995–1998 Toyota T100 in Base, DLX, DX and SR5 trims.
Other Toyota trucks and years outside 1995 to 1998 are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that the brackets sit square against their mounting points before the bar takes any weight.
What’s included
The brackets come with the step.








