Overview
The Welcome Distributing GraBars 1018 are solid steel interior grab handles with black rubber grips. They help you get in and out of a Jeep or hold on along a trail. The handles are universal fit and mount in the front position.
The GraBars install without drilling or dismantling. The 3/4 inch steel is solid rather than tubing, and the handles are made in the USA.
Key features
- 3/4 inch solid steel, not tubing
- Black rubber grips
- Solid mounted handles that assist entering and exiting
- Installs without drilling or dismantling
- Limited Lifetime Warranty
- Made in the USA
Getting in and out safely
Grab handles on an off-road vehicle carry more load than many people expect, especially when stepping up into a high cabin or bracing over a rough section. A solid steel bar keeps its shape under that load, and rubber grips make it easier to hold with wet or gloved hands. Pick a spot where your hand falls naturally when you swing in.
Think about how you will move in and out before choosing a spot, since the handle should sit where it is easy to reach. Loosening hardware is a common problem, so tighten fasteners after the first few drives and again at routine service. Look for rust at the mount, cracked grips, and any movement when the handle is pulled.
- Clean the grips with mild soap and water
- Inspect the mount after rough trails
- Replace grips that crack or peel
Specifications
| Brand | Welcome Distributing |
|---|---|
| Part number | 1018 |
| UPC | 857131005103 |
| Color | Black grips |
| Bar material | 3/4 inch solid steel |
| Position | Front |
| Warranty | Limited Lifetime |
| Quantity | Pair |
Vehicle fitment
They are universal fit, not built for one Jeep model. Mount them in the front position and confirm the spot you choose is solid before installing.
Installation notes
Installing the GraBars requires no drilling or dismantling. Check that the mount is solid before putting your full weight on the handle.
What’s included
A pair of GraBars with black grips.


















