Overview
The Welcome Distributing Front and Rear GraBars with black grips (part number 1003) are solid steel interior grab bars for a Jeep. They give passengers something to hold when getting in and out, and something to grip on a trail. Welcome Distributing names 2-door models but gives no years or model codes.
Each bar bolts into existing holes with grade 12.9 bolts, so installation needs no drilling or dismantling. The install takes about 10 minutes.
Key features
- Solid 3/4 inch steel bars
- Black rubber grips
- Front and rear positions in one kit
- Bolts into existing holes with no drilling
- Limited Lifetime Warranty
- Made in the USA
Before you install
Grab bars help passengers steady themselves on rough ground, and they also support getting in and out of a high-sided vehicle. Their value depends on how securely they are fastened, so the bolts and the body structure they thread into matter as much as the bar itself. Before using a bar to take weight, check that it does not rotate or shift under a firm pull in several directions.
Bolt-on grab handles often loosen from vibration over time. Retorque the fasteners after the first few trail runs and again at intervals, and inspect the rubber grips for cracks, tears or softening. A grip that spins or slides on the steel should be replaced, since a slipping grip gives the hand less to hold.
If you add a roll bar, hardtop or other upgrades later, look at where the bars sit relative to the new parts before drilling anything. Keep the bolts and washers together in a dry place so they are ready for reinstallation.
- Check bolt torque after the first trail outings
- Inspect grips for cracking or slipping
- Confirm clearance before adding other interior gear
Specifications
| Brand | Welcome Distributing |
|---|---|
| Part number | 1003 |
| UPC | 857131005042 |
| Position | Front and Rear |
| Color | Black |
| Grip | Black rubber |
| Steel | 3/4 inch solid steel |
| Mounting | Grade 12.9 bolts into existing holes |
| Kit contents | 4 GraBars |
| Warranty | Limited Lifetime |
| Origin | Made in the USA |
Vehicle fitment
These GraBars bolt into existing holes in the Jeep, so match them to your year, model and trim before buying.
It fits 2-door models. Match your year, model and trim before buying.
Installation notes
Each GraBar bolts into existing holes with grade 12.9 bolts and needs no drilling. Installation takes about 10 minutes. Check that every bolt is tight before the bar takes body weight.
What’s included
A kit of 4 GraBars with black rubber grips, for the front and rear positions.
























