Overview
The Trail Gear 110027-1-KIT is a rear shackle mount kit for the 1984–1995 Toyota 4Runner and the 1979–1995 Toyota Pickup.
A rear shackle mount holds the rear end of a leaf spring to the frame. Trail Gear explains that installing longer rear springs may require relocating the original shackle mount, either by cutting off the original units with a die grinder and welding them back on, or by cutting off the old ones and installing new ones.
These new shackle mounts use OEM bushings, and Trail Gear says they are much stronger than the stock units. They are made from 1/4 inch plate steel with an unpainted finish.
Check the kit contents against your installation before starting any cutting, and confirm the trim details for your vehicle before ordering.
Key features
- Rear shackle mount kit
- Made from 1/4 inch plate steel
- Uses OEM bushings
- Unpainted finish
- Designed for relocating the rear shackle mount when installing longer rear springs
- Direct-fit design for 1984–1995 Toyota 4Runner and 1979–1995 Toyota Pickup
Rear spring and shackle geometry
Rear shackles let a leaf spring change length as it flexes, so the mounting point sets how the axle moves over bumps. When longer springs are fitted, the shackle position can shift the spring’s arc and the pinion angle, which affects driveline vibration and ride. Measure the spring eye positions and the axle location before cutting anything, and mark the planned mount locations on the frame.
Bare steel mounts need protection once installed. Clean welds, remove slag and apply a rust inhibitor or paint to the new plate, especially around bushing sleeves where water collects. Inspect the bushings at each oil change, and replace them when they show cracks, wear or play. After any spring change, recheck the shackle bolts, U-bolts and brake lines once the vehicle has been driven for a short distance.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 110027-1-KIT |
| UPC | 70000621743 |
| Product type | Shackle mount kit |
| Position | Rear |
| Material | 1/4 inch plate steel |
| Finish | Unpainted |
| Bushings | Uses OEM bushings |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Trail Gear 110027-1-KIT covers these Toyota vehicles:
- 1984–1995 Toyota 4Runner (DLX, SR5)
- 1979–1995 Toyota Pickup (Base, Base Turbo, DLX, DLX Turbo, SR5, SR5 Turbo)
The list does not include the Toyota Tacoma, Tundra or other Toyota models, or model years outside the ranges shown. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
- Support the vehicle on jack stands on level ground before cutting off the original shackle mounts.
- Check the shackle bolts and mounting hardware after the first drive.
- Check the alignment and the driveline and brake line clearance afterward, since the spring geometry changes.
- Installation involves cutting off the original shackle mounts and welding, so use a qualified welder and treat bare steel against rust since the finish is unpainted.
What’s included
Not included: Longer rear springs and shackles are not included with this kit.









