Overview
The 8 in Rock Assault axle limit strap from Trail Gear, part 111271-KIT, uses six-layer nylon webbing to restrict how far a shock can extend. Restricting that travel helps protect the shock from breakage on rough terrain.
Trail Gear calls its six-layer design the industry’s first of this type, built with minimal stretch for extreme trail use. Universal fit applies, so the shock’s length decides which strap suits your setup.
Because the strap is made for a shock rather than a vehicle, the specification table gives the length, rating, hole size and tolerance in one place for quick comparison.
Key features
- Woven six-layer nylon webbing with minimal stretch.
- Buckles of 4130 heat-treated Chromoly Steel, zinc-plated for corrosion resistance.
- Clips that resist abrasion, installed in every buckle.
- Nylon rated at 9,000 lb test.
- Half-inch mounting holes, with length tolerance of +/- 1/4 inch.
Protecting the shock on rough ground
On rough ground, the axle can travel farther than the shock was designed to extend. A limit strap holds the shock short of that point, reducing the strain on the shock body, seals and mounts. Choosing the right strap length is part of getting that protection, so measure the shock before buying.
A short strap suits a short shock and a stiffer setup, while a longer strap suits longer shocks with more travel. Keep the strap clear of moving parts, and avoid routing it over sharp edges, which can cut the webbing over time. Inspect the buckles and clips after each trail day.
- Keep the strap away from sharp edges
- Check clips for wear after trail use
- Measure the shock before ordering
- Store spare straps dry and out of sunlight
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 111271-KIT |
| UPC | 70000640905 |
| Length | 8 in |
| Layers | Six |
| Webbing | Nylon |
| Test rating | 9,000 lb test |
| Buckle material | 4130 heat-treated Chromoly Steel |
| Buckle finish | Zinc-plated |
| Mounting holes | 1/2 inch |
| Length tolerance | +/- 1/4 inch |
| Sold | Individually |
Vehicle fitment
Universal fit is how Trail Gear classifies this strap, so no year, make, model or trim is attached to it. Use the shock’s length to decide whether the 8 in size works for your setup.
Installation notes
Pick a strap about one inch shorter than the shock it protects. Measure from the center of the 1/2 inch mounting holes, since that is where Trail Gear takes the length.
What’s included
The strap is sold individually.
Not included: Shocks and mounting bolts are not part of this kit, so have them ready before installation.




