Overview
The Gorilla Whips Split Bolt Flag Mount is a split bolt for attaching a whip flag to a fiberglass whip pole that is 1/4 inch in diameter. It is classified in the CB antennas and mounts category as an antenna mount accessory. It works as a mount for the flag itself, with no vehicle tied to it.
Key features
- Split bolt design for mounting a whip flag
- Made for 1/4 inch diameter fiberglass whip poles
- Classified as an antenna and mount accessory
Pole and flag setup
A whip flag mount carries the flag high above the vehicle, so the connection between the flag, the split bolt and the pole has to stay tight. Vibration on rough trails and highway wind both work on the joint. The split bolt clamps the pole in place, so the fit at that point matters more than the flag itself. Choose a pole whose diameter matches the mount, and avoid forcing a pole that is slightly off-size into the opening, since that can crack the fiberglass or leave the clamp loose.
Inspect the pole and mount after each outing where the trail was rough. Look for hairline cracks in the fiberglass, worn threads and a loose flag. Tighten the fastener by hand first, then snug it to avoid crushing the pole. If the pole shows splintering near the clamp, replace it rather than re-using the damaged section.
Specifications
| Brand | Gorilla Whips |
|---|---|
| Product type | Split bolt flag mount |
| Pole diameter | 1/4 inch (fiberglass whip poles) |
| UPC | 852451006090 |
Vehicle fitment
No vehicles are confirmed for this mount. Confirm your whip pole diameter and antenna setup match the mount before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The split bolt is the item offered here. Check the package contents against your installation before starting.









