Overview
The Smittybilt Truck Tie Down Anchor and Strap Kit, part 18603, includes two anchors and two straps for securing cargo in a truck bed. The anchors are made from 3/16 inch cold rolled steel with a two-stage textured matte black powder coat. The kit is universal fit, so check the bed rail layout on your truck before ordering.
The design uses a low profile with seven anchor points per rail, so several items can be secured at once. The anchors offer a variety of options for different types of cargo and have no moving parts or connections that could be lost or break.
The anchoring studs are high strength and install through a quick nut plate, which spreads the load across the bed panel. Grade 8 hardware is used throughout. Some drilling is required for the install.
Key features
- Includes two anchors and two straps
- 3/16 inch cold rolled steel
- Two-stage textured matte black powder coat
- Low profile design
- Grade 8 hardware
- Seven anchor points per rail
- Quick install nut plate spreads the load
Anchor placement and load safety
Cargo anchors only work as well as their placement. Mark the positions before drilling, and think about where loads will sit so straps can pull from a useful angle. Anchors set too close together or too far from the cargo can limit how well items are held during a sudden stop or a sharp turn on a rough road.
Because the anchors bolt into the bed, the bed floor and rails take the strain. Check the nut plates and fasteners after the first few uses, and confirm that the straps are rated for the loads you plan to carry. Keep the bed clear of debris so the anchor area can be inspected easily.
- Mark anchor positions before drilling
- Check nut plates and fasteners after early use
- Match strap ratings to the load
- Inspect straps for cuts and worn stitching
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 18603 |
| UPC | 631410114225 |
| Material | 3/16 inch cold rolled steel |
| Finish | Two-stage textured matte black powder coat |
| Hardware | Grade 8 |
| Anchor points | Seven per rail |
Vehicle fitment
The kit is universal fit. Because the anchors mount to the truck bed, fit depends on the bed rail layout, so measure the bed before ordering.
Installation notes
Some drilling is required, and the anchors use a quick install nut plate. Plan the anchor positions before drilling starts, with seven points per rail.
What’s included
Two anchors and two straps.
















