Overview
The Curt Manufacturing Surface Mounted Tie-Down D Ring, part number CRT83732, is a steel anchor point that mounts to the surface of a trailer, truck or full-size van. It gives cargo straps, ropes or cables a secure place to hook on. It is a universal fit mounting part rather than a vehicle-specific one.
Unsecured cargo is a hazard to you, your passengers and other drivers, and it can also damage the trailer, the pickup bed, a cargo area or the cargo itself. Curt also offers cargo straps and safety chains that work with anchors like this one. The D-ring shape holds ropes, cables and strap hooks in one spot, and this model has a 1,200 lb capacity with a stainless finish over steel construction.
Key features
- Surface mounted design for trailers, trucks and full-size vans
- D-ring anchoring point for cargo straps, ropes or cables
- Steel construction with a stainless finish
- Capacity of 1,200 lbs
- Mounting bracket 2 1/4 inch x 13/16 inch
- Two 1/4 inch diameter mounting holes spaced 1 1/2 inch apart, center to center
Mounting on a flat surface
A surface mounted anchor is only as strong as the panel it is fixed to. Thin sheet metal, hollow panels and painted trailer walls can flex or tear under a load, so the mounting surface should be solid and sound. Mark the hole layout carefully, drill pilot holes straight, and check that the bracket sits flat before tightening anything, since a bracket that rocks will load the fasteners unevenly.
Corrosion is the main long-term concern. Where bare metal is exposed by drilling, a light coat of paint or sealant helps keep water out of the holes. Tighten fasteners firmly but avoid overtightening, which can crack a thin panel. Recheck the anchor after the first few loads, since shifting cargo can settle a mount that was not seated well.
- Use a solid mounting surface free of rust
- Add a backing plate on thin or hollow panels
- Seal bare drilled metal against moisture
- Recheck tightness after the first few loads
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT83732 |
| Type | Surface mounted tie-down D-ring anchor |
| Material | Steel |
| Finish | Stainless |
| Capacity | 1,200 lbs |
| Mounting bracket | 2 1/4 inch x 13/16 inch |
| Mounting holes | Two, 1/4 inch diameter, spaced 1 1/2 inch apart center to center |
Vehicle fitment
This D-ring anchor is a universal fit, so it is not tied to a specific year, make or model. It is intended for trailers, truck beds and full-size vans where a surface mount location is available. Check the bracket size and the 1 1/2 inch hole spacing against your mounting surface before you mount it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mounting screws are not included, so choose fasteners that suit your mounting surface. The two 1/4 inch holes are spaced 1 1/2 inch apart, center to center, so the screw layout must match that spacing.
What’s included
The anchor comes with a 2 1/4 inch x 13/16 inch mounting bracket and two 1/4 inch mounting holes.
Not included: Mounting screws.










