Overview
The Smittybilt Tailgate Table is a 1/8 inch steel fold-out table for the Jeep Wrangler JK. It fits both two-door and four-door JK Wranglers, which Jeep built from 2007 to 2018, and it clears the factory subwoofer. Smittybilt designed it to hold food, tools and camp gear up off the dirt.
The table is only 1-1/2 inches thick when closed, so it takes up little space in storage. It can be mounted inside or outside the vehicle, with the table top up or down to suit the owner. Heavy-duty spring-loaded pull pins lock the table in position, and the built-in cup holders keep drinks out of the way.
Smittybilt also points out that the table is a workable bench for trail repairs. Its load limit of 30 pounds covers most camp cooking gear, but it is not a platform for heavy equipment. Plan the mounting points before the install, since the table needs drilling.
Smittybilt designed the table to be used in camp as well as on the trail, so the 30 pound limit and the cup holders are the two numbers to keep in mind when you load it.
Key features
- 1/8 inch steel construction that holds up to 30 pounds
- Built-in cup holders to keep drinks off the dirt
- Heavy-duty spring-loaded pull pins lock the table in place
- Mounts inside or outside, with the table top up or down
- Low profile when closed, at 1-1/2 inches thick
Before you drill
Mark every mounting point with the table closed and open before you drill, and check for wiring, fuel lines and brake components behind the panel. Measure twice, since a drill that wanders into the interior can cause damage that is hard to repair. Deburr the holes so the mounting hardware seats evenly.
A steel table adds weight at the rear, so keep loads within the rated limit and spread them across the surface. Heavy tools and coolers belong on the floor instead, where they are secured. Trail vibration can loosen fasteners, so recheck them after the first few trips.
Think about where you will sit when the table is open. Leave room for the tailgate to swing and for passengers to move around the rear.
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 2793 |
| UPC | 631410125634 |
| Material | 1/8 inch steel |
| Load capacity | 30 pounds |
| Thickness when closed | 1-1/2 inches |
| Mounting | Inside or outside, table top up or down |
Vehicle fitment
It fits the 2007 to 2018 Jeep Wrangler JK in two-door and four-door form. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires drilling, so mark the mounting points before you start. The table is designed to clear the factory subwoofer on JK models.
What’s included
Check the package contents against your installation before starting, and confirm you have all mounting hardware before you begin drilling.




























