Overview
The Rugged Ridge 11542.14 is a black powdercoated tubular over-rider hoop for the All Terrain modular front bumper and the aluminum XHD modular front bumpers on the 2007-2018 Jeep Wrangler JK, in 2 or 4 door models. It bolts directly to the bumper’s center base section.
The hoop works with or without a winch, but it does not fit a Warn Powerplant W71800 winch. Use it with number 11542.02.
Key features
- Tubular over-rider hoop
- Black powdercoated finish
- Fits All Terrain and aluminum XHD modular front bumpers
- Bolts directly to the center base section
- Usable with or without a winch
Choosing a winch and hoop match
An over-rider hoop sits at the outer corner of the bumper, where it takes impacts from rocks and trees and guards the lights and grille. A tubular hoop bolted to the center base section keeps the load spread across the bumper rather than the corners, which helps when the vehicle pushes through brush. Because the hoop mounts to the center section, the bumper itself has to be in good condition before the hoop is added.
Winch choice is the most important compatibility question for this part. Confirm the winch model’s mounting pattern and clearance against the hoop before buying, and do not assume a winch will clear because the bumper is compatible. If a winch is later swapped for a different model, check that the new unit still clears the hoop and the fairlead line.
Hoop bolts and mounting points deserve periodic checks, especially after hard trail use. Look for cracks in the powder coat at the attachment points, movement of the hoop when pushed by hand, or gaps where the hoop meets the bumper. Address any movement quickly so the center base section does not take the strain.
- Check the winch model against the hoop before purchase.
- Inspect the mounting points after rough trail use.
- Replace bolts that show stretching or corrosion.
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11542.14 |
| UPC | 804314250140 |
| Product type | Over-rider hoop for modular front bumper |
| Position | Front |
| Finish | Black powder coat |
| Compatible bumpers | All Terrain and aluminum XHD modular front bumpers; use with 11542.02 |
| Winch compatibility | Not compatible with Warn Powerplant W71800 |
| Fit type | Direct fit |
Vehicle fitment
The 11542.14 fits 2007-2018 Jeep Wrangler JK models in 2 or 4 door versions.
The hoop is for the All Terrain and aluminum XHD modular front bumpers only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
If you plan to run a Warn Powerplant W71800 winch, choose another hoop, because this one will not fit with it.
What’s included
One tubular over-rider hoop.
Not included: The bumper’s center base section.









