Overview
The SPOD VVPZCJK-512R is a replacement rocker switch for roof-mounted light bars. It is sold under the SPOD brand and is meant to be used as the control for a roof-mounted light bar.
The switch is universal fit, so compatibility depends on your light bar and wiring rather than any particular vehicle.
Key features
- Replacement rocker switch for roof-mounted light bars
- It shows which function it controls, so the switch position is readable at a glance.
- Marked Universal Fit
- Brand SPOD, part number VVPZCJK-512R
Wiring a light bar switch
A light bar draws a lot of current, so the switch should only carry the signal to a relay, not the full load. Wire the relay near the battery with its own fuse, and run the switch circuit through the relay coil. Using the switch as a relay trigger keeps contacts cool and makes a fault easier to trace.
Look at the switch position when you install it. A rocker that shows its state helps you confirm the light bar is on without looking at the bar itself. Route the cable through the roof or pillar away from pinch points, and seal any entry hole so water stays out of the cabin.
- Use a relay between the switch and the light bar
- Fuse the feed close to the battery
- Seal any roof or pillar entry point
Specifications
| Brand | SPOD |
|---|---|
| Part number | VVPZCJK-512R |
| UPC | 700008018951 |
| Type | Rocker switch, replacement |
| Fitment | Universal Fit (no vehicle years or models listed) |
Vehicle fitment
No vehicle years, makes or models are tied to it. It is universal fit, so it is not bound to one vehicle, but it still has to match the wiring of your light bar.
Check the switch against your light bar’s wiring and your vehicle’s year, model and trim.
Installation notes
Light bar switches are often wired through a fused relay. Follow your light bar’s own wiring steps and local rules on road-use lighting.
What’s included
Check the package contents against your installation before starting.
Not included: the roof-mounted light bar it operates.









