Overview
The Rock Slide Engineering passenger-side standard actuator, part BD-SS-500-PASS, is a motor for the R-SE Step Sliders. It is made in the USA and pairs with Rock Slide Engineering Step Sliders.
Installing a passenger-side motor
Installing a side-specific motor is mostly a matter of matching the unit to the slider and keeping the mounting area clean. The passenger side and driver side units are separate parts, so a quick check of the position marking before you begin prevents a wrong fit. Set the new motor in the same orientation as the old one, and keep fasteners and connectors together so nothing is lost.
After installation, run the step through a full cycle and listen for binding or uneven movement. Confirm the wiring is secure and clear of moving parts. If the step does not travel smoothly, recheck the alignment before assuming the motor is at fault.
- Match the position marking before starting
- Keep fasteners and connectors together
- Run the step through a full cycle
- Check wiring clearance from moving parts
Specifications
| Brand | Rock Slide Engineering |
|---|---|
| Part number | BD-SS-500-PASS |
| UPC | 88775311406 |
| Position | Passenger side |
| Component | Motor for R-SE Step Sliders |
| Origin | Made in the USA |
Vehicle fitment
It is tied to the R-SE step sliders rather than to a make or model. Confirm the R-SE slider it will pair with before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This unit is the passenger-side motor. The driver-side motor, BD-SS-500-DRIVE, is a separate part, so confirm the side and slider model before you start.
What’s included
One passenger-side standard actuator is described.
Not included: Confirm your step slider is on hand and matches this side before installing.












