Overview
The Rhino-Rack 2500 Fitting Kit, part number DK174F, is a half kit that replaces the pads and clamps on a Rhino-Rack 2500 one bar roof rack. It contains two santoprene pads and two black steel clamps, and it fits the 2005–2018 Toyota Tacoma in the Base, Limited, Pre Runner, SR, SR5, TRD Off-Road, TRD Pro and TRD Sport versions.
The half kit covers one side of a one bar rack, so it suits a rack that uses only two attachment points. The steel is finished in black powder coat, and Rhino-Rack lists drilling as not required.
Key features
- Two santoprene pads
- Two anti-corrosive black metal clamps
- Black powder coat finish on the steel
- Drilling not required
Steel clamps and corrosion care
Steel clamps are strong, but their black powder coat is the main barrier against rust. Road salt, mud and repeated wet and dry cycles wear through the coating over time, and once bare metal shows, corrosion can start quickly around the clamp edges. A regular rinse with clean water after trips on salted or muddy roads keeps that film intact for much longer.
On a one bar rack, the two clamps carry the load on their own, so their condition matters more than it would on a larger set. Look at the contact faces where the clamp meets the bar and the pad, and check that the clamp still grips without play. Keep a few spare fasteners on hand so a missing bolt can be replaced before the next trip.
- Rinse clamps after salted or muddy drives
- Touch up chips in the powder coat early
- Check for play where the clamp meets the bar
Specifications
| Brand | Rhino-Rack USA |
|---|---|
| Part number | DK174F |
| Part type | Half fitting kit, one bar 2500 system |
| Pads | 2 santoprene |
| Clamps | 2 black metal |
| Material | Steel |
| Finish | Black powder coat |
| Cross bars included | No |
| Installation | Drilling is not required |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2005–2018 Toyota Tacoma in the Base, Limited, Pre Runner, SR, SR5, TRD Off-Road, TRD Pro and TRD Sport versions. The two bar Tacoma kit is the separate DK174.
The two bar Tacoma kit (DK174) is a different part, and the Tundra and Frontier are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check that the rack is a one bar 2500 system before fitting, since the two bar kit has a different number of pads. Tighten the clamps only after the pads sit flat on the roof.
What’s included
Two santoprene pads and two black metal clamps.
Not included: cross bars and the rest of the one bar rack.









