Overview
The Pro Comp snap-in valve stem, part number PXA11131, is a valve stem from the Pro Comp Alloy Wheels line. It is a universal fit part, so it is not tied to a named vehicle.
A snap-in valve stem is pressed through the valve hole in a wheel rim and held by friction, with no nut on the inside of the rim.
Inspecting and replacing valve stems
Valve stems are small parts with a large job, because they hold the air that keeps the tire seated and sealed. Rubber stems dry out, crack and split over time, especially with sun and temperature swings. A snap-in stem pressed through the valve hole is simple to replace, but the rim hole must be clean and undamaged for the new stem to seal.
Some vehicles use tire pressure sensors built into the valve stem. Those sensor stems are separate parts from a standard snap-in stem, so check which type your wheel uses before ordering. When a tire is removed for service, inspect the stem and its seal, and replace any stem that shows cracks, bulges at the base or a slow leak.
- Check stem rubber for cracks and splits
- Clean the rim valve hole before fitting
- Confirm whether the wheel uses a sensor stem
Specifications
| Brand | Pro Comp Alloy Wheels |
|---|---|
| Part number | PXA11131 |
| Type | Snap-in valve stem |
| Installation | Pressed through the wheel valve hole |
| Fitment | Universal fit label; no vehicle named |
Vehicle fitment
No vehicle is named for this valve stem. Universal fit does not match it to a specific wheel.
Fit depends on the valve hole in your wheel. Measure the hole and check it against your wheel before fitting the stem.
What’s included
One valve stem.









