Overview
The Pro Comp 51255 is a driveline alignment shim kit for lifted trucks with a two-piece rear driveshaft. It covers Chevrolet Silverado, GMC Sierra and Dodge Ram models shown under vehicle fitment.
Lifted trucks with a two-piece driveshaft need the carrier bearing spaced down, and this kit has the shims for that job. The kit is a 2.5 degree shim set and comes without center pins.
Key features
- Driveline alignment shim kit for two-piece rear drive shafts
- 2.5 degree shim
- Without center pins
Driveline angles after a lift
When a truck is lifted, the front of the rear driveshaft and the transfer case output tilt in ways the factory setup did not expect. A two-piece driveshaft uses a carrier bearing to keep the shafts in line, and spacing that bearing down reduces the angle that would otherwise stress the joints. Shims are the usual way to make that correction, so the kit’s job is to move the bearing into the right position.
After installation, check for vibration at highway speed, clicks or binding in the joints, and any drone that changes with speed. Inspect U-joints and the carrier bearing for play. If the vibration returns, the angle may need rechecking because suspension changes shift the driveline geometry. Keep the shim and hardware notes with the vehicle records for future service.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 51255 |
| UPC | 614901180862 |
| Type | Driveline alignment shim kit |
| Angle | 2.5 degrees |
| Center pins | Without center pins |
Vehicle fitment
It fits the 2001–2003 and 2005–2006 Chevrolet and GMC 1500 HD models, the 2001–2010 Chevrolet Silverado and GMC Sierra 2500 HD models, and Dodge Ram 2500 and 3500 trucks from 1994 to 2010. It also fits the 2001–2003 Silverado and Sierra 1500, the 2001–2004 Silverado and Sierra 2500, and the 2007 HD Classic trucks.
The list does not include the 2011 and later Silverado or Sierra trucks, or the Ford F-250 and F-350 Super Duty. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Lifted trucks need the carrier bearing spaced down on a two-piece rear driveshaft, and this shim kit is what does that job. Check the driveline angles after the lift is installed, since lift height changes them.
What’s included
Driveline alignment shim kit.
Not included: Center pins, which are not supplied with this kit.









