Overview
The Power Stop K206 (part number PSTK206) is a rear brake kit with drilled and slotted rotors and Z23 Evolution Sport ceramic pads. It fits the 2010-2018 Acura RDX and the 2005-2016 Honda CR-V. The Z23 pads use carbon fiber infused ceramic, paired with performance rotors.
The slots improve pad bite and air circulation, while the drilled holes and slots give debris, dust, gases and water a way out. The rotors are silver zinc plated with Tru-Cast technology, and the kit is for the rear brake position.
Key features
- Evolution drilled and slotted performance rotors
- Z23 Evolution Sport carbon fiber infused ceramic brake pads
- Premium hardware, plus a pin bushing kit and hi-temp lubricant
- Slots add pad bite and improve air circulation
- Drilled holes and slots create an escape route for debris, dust, gases and water
- Slots clean and de-glaze the pad surface
- Silver zinc plated rotors that are coated
- Reduced rotor weight and a different appearance behind the wheels from the drilled design
Choosing the right setup
Drilled and slotted rotors suit drivers who want a sporty look and a bit more pad contact in everyday driving. Carbon fiber infused ceramic pads are gentler on rotors than many metallic compounds, yet they still need a bed-in period to reach full bite. Keep the rear axle set together, because uneven pads or rotors can pull the vehicle under braking.
Related parts are often replaced at the same time. Caliper slide pins should move freely, and the boots should seal without tears. Fresh brake fluid helps the system respond consistently after new pads go in. Inspect the wheel bearings and rear hardware for play before fitting the new parts, since a loose component can mimic brake noise.
- Check caliper pins and boots during pad changes
- Replace brake fluid when it looks dark or is past its service interval
- Look for scoring, heat blue spots or cracks on the rotor face
- Keep pad and rotor pairs matched on the same axle
Specifications
| Brand | Power Stop |
|---|---|
| Part number | K206 |
| UPC | 792088529022 |
| Product type | Disc brake pad and rotor kit |
| Brake position | Rear |
| Rotor type | Slotted and cross drilled |
| Rotor coating | Coated (silver zinc plated) |
| Brake pads | Z23 Evolution Sport carbon fiber infused ceramic |
| Hardware | Premium hardware, pin bushing kit and hi-temp lubricant |
| Brake lines | Not included |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2010-2018 Acura RDX (Base, SH-AWD) and the 2005-2016 Honda CR-V (EX, EX-L, LX, SE, Touring). It is for the rear axle only.
The kit is for the rear brakes only. Confirm your vehicle’s year, model and trim before ordering, since fit is limited to the years and models above.
Installation notes
Brake work is safety-critical, so have it done by a professional where possible. Support the vehicle securely on jack stands on level ground, keep brake surfaces free of oil and grease, and tighten all fasteners to the torque values in your service manual. Bed the pads and rotors in gradually, check the brake fluid level, and test the brakes at low speed before normal driving. Re-check the wheel fasteners after the first miles of driving.
What’s included
Drilled and slotted rotors, Z23 Evolution Sport ceramic brake pads, premium hardware, and a pin bushing kit with hi-temp lubricant.
Not included: Brake lines and brake fluid are not included.









