Overview
The Oracle Lighting Black Series LED Tail Lights, part number ORC5852-504, are LED tail lamps for the 2018–2026 Jeep Wrangler (JL), covering both 2-door and Unlimited 4-door models. They replace the factory tail lamps with a blacked-out housing and an hour-glass LED design.
The lamps upgrade every tail lamp function: driving lights, brake lights, reverse lights and turn signals. Oracle says they plug directly into the factory JL tail light socket and that the load equalizers are pre-wired, so no dash warning lights should appear. The housing carries an IP67 waterproof rating, and Oracle states they fit JL Wranglers without the factory LED package.
Key features
- Blacked-out, aggressive styling
- Hour-glass LED design
- LEDs for driving, brake, reverse and turn signal functions
- Plug-and-play connection to the factory JL tail light socket
- Pre-wired load equalizers
- IP67 waterproof rating
Wiring and warning lights
Tail lamp upgrades change the electrical load the vehicle’s systems see. Pre-wired load equalizers are built into the lamp harness so the LED circuits draw enough load to avoid dash warnings. Keep the harness routed away from moving parts and hot exhaust components, and make sure each connector clicks fully into place.
After installing, test every function: driving, brake, reverse and both turn signals. A failed LED in a lamp is rare, so a dead function usually means a connector, fuse or ground problem. Water sealing depends on clean gaskets, so inspect the seal whenever the lamp is removed.
- Test brake, reverse and turn functions
- Check connector latches and seating
- Keep wiring clear of moving parts
- Inspect lamp gaskets after washing or off-road use
Specifications
| Brand | Oracle Lighting |
|---|---|
| Part number | ORC5852-504 |
| Product line | Black Series LED tail lights |
| Waterproof rating | IP67 |
| Lamp functions | Driving, brake, reverse, turn signal |
| Housing | Blacked-out |
| LED design | Hour-glass |
| Connection | Plug-and-play to factory socket |
| Load equalizers | Pre-wired |
Vehicle fitment
The lamps fit the 2018–2026 Jeep Wrangler (JL), including 2-door models and Unlimited 4-door models in Sport, Sport S, Willys, Rubicon, Sahara, Moab and 4xe trims, plus the Unlimited Rubicon 392. They also fit all JL Wranglers without the factory LED package.
Earlier Wrangler generations, including JK, and the Jeep Gladiator (JT) are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The lamps plug into the factory JL tail light socket, so installation is plug-and-play. The pre-wired load equalizers are built in to prevent dash warning lights, so no separate equalizer is needed.
What’s included
The included items are the tail lamps with pre-wired load equalizers.

















