Overview
The Omix-ADA 17744.01 is a vent hose clamp for Jeep heating and cooling hoses. It is a direct OE replacement built to original specifications and is universal fit, so it is not tied to one model year, model or engine. Measure the vent hose before choosing this clamp, since the clamp’s size must suit the hose diameter.
Vent hose clamp tips
A vent hose carries air or vapor in a heating or cooling circuit, and its clamp keeps the joint sealed under heat and vibration. A clamp that is too loose lets the hose slip or seep, while one that is too tight can deform the hose end.
Before buying, measure the hose diameter at the point where the clamp will sit, then compare it with the clamp’s range. Universal fit clamps depend on the hose and fitting more than on the vehicle, so the hose size is the deciding check.
After installation, check the joint for drips, odor or a loose hose after a few heat cycles. Replacing a hardened or cracked hose at the same time is a sensible step, since a fresh clamp will not seal a worn hose end. Inspect the clamp periodically for corrosion.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 17744.01 |
| UPC | 804314000929 |
| Category | Heating and Cooling, Hose Clamp |
| Warranty | Limited five year warranty. |
Vehicle fitment
It is a universal fit clamp, so it is not vehicle-specific. Confirm the clamp size against the vent hose before installing it.
What’s included
The clamp, part number 17744.01, is the only item included.









