Overview
The Omix-ADA 12029.01 is a rubber grille to hood bumper that installs by push-in. It is a direct OE replacement Jeep part, built to original specifications, with a limited five year warranty.
Fit is unconfirmed, since no model years or chassis codes are named for it.
Key features
- Rubber construction
- 3/16 inch thickness
- Push-in installation
- Direct OE replacement built to original specifications
Grille bumper care
Grille to hood bumpers cushion the front of the hood and reduce rattles where the panel closes. Rubber bumpers compress under pressure and recover, so they need to sit squarely on the mounting surface. Heat and sun speed up hardening and cracking in rubber over time. A worn or flattened bumper can let the hood seat unevenly and cause a loose feel at the front edge.
Replacing a bumper is simple, but the surface underneath deserves attention. Clean the old residue from the grille and hood edge before pressing the new piece in place. Check that the bumper is in the correct position and that the hood closes evenly. Replace bumpers in sets where the vehicle has more than one, so they wear and sit at the same height.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 12029.01 |
| UPC | 804314037161 |
| Material | Rubber |
| Thickness | 3/16 inch |
| Mounting | Push-in |
| Warranty | A limited five year warranty applies to this bumper. |
Vehicle fitment
Fit is unconfirmed. It is a Jeep OE replacement, but no model years or chassis codes are named.
Compare the bumper with your current part before fitting. Check your year, model and trim before ordering.
What’s included
Package contents are not confirmed. Check the package contents against your installation before starting.









