Overview
The Omix-Ada 12008.03 is a rear center panel assembly for the 1946–1949 Jeep Willys CJ-2 and the 1949–1953 Jeep Willys CJ-3. It is a rear position floor section for owners repairing early Willys CJ models.
Omix-Ada designed it as a direct fit in the rear position.
Key features
- Rear center panel assembly
- Rear position
- Direct fit per the manufacturer fitment list
- Covers the CJ-2 and CJ-3 model years listed in the fitment section
Before you repair
Floor and rear panel repairs on early Willys bodies usually start with checking the surrounding structure. Look at the crossmembers, floor supports and body mounts for rust before fitting a new panel, because a sound panel on weakened supports will flex and crack the welds. Remove loose paint and surface rust down to bare metal so the new panel sits flush and the seam welds are clean.
Trial fit the panel with the tub in place before welding or fastening, and mark any high spots that need trimming. Protect the new panel with primer and sealer on the underside and inside seams, since moisture trapped in the floor is a common cause of early repair failure on older Jeeps. Recheck the fit once the panel is fastened.
- Inspect supports and body mounts for rust
- Prime seams before final assembly
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12008.03 |
| UPC | 804314011710 |
| Position | Rear |
| Model years | 1946–1949 Jeep Willys CJ-2; 1949–1953 Jeep Willys CJ-3 |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list covers the 1946–1949 Jeep Willys CJ-2 and the 1949–1953 Jeep Willys CJ-3. The list does not include the CJ-5, CJ-7 or later Wrangler models.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Confirm you have the fasteners your installation requires before starting.









