Overview
The Omix-Ada Valve Cover Nut, part number 17402.07, is a direct OE replacement Jeep part built to original specifications. Omix-Ada backs it with a limited five year manufacturers warranty.
Confirm fit for your vehicle’s year, model and trim before ordering, and match the nut against your existing valve cover.
Key features
- Direct OE replacement design
- Built to original specifications by Omix-Ada
- Limited five year manufacturers warranty
Valve cover nut basics
Valve cover nuts hold the valve cover to the cylinder head and help seal the top of the engine. Over time the threads can strip, the nut can corrode, and the washer under it can flatten, which allows oil to seep past the gasket. A worn nut may spin or feel loose when tightened, and that is a sign to replace it rather than keep torquing it down.
When replacing one, clean the stud threads and the mounting surface first. Use a nut with the same size and thread pattern, and reuse any washer or grommet that came with the old nut. Tighten in small, even steps so the cover seats flat, and avoid overtightening, since that can crack the cover or strip the stud.
- Inspect the stud threads for damage before fitting
- Replace a nut that spins or shows corrosion
- Check for oil seepage after the first warm-up
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17402.07 |
| UPC | 804314061715 |
| Warranty | Limited five year manufacturers warranty |
Vehicle fitment
This is a direct fit nut, with no specific vehicle, year or engine named for it.
Confirm your vehicle’s year, model and trim before ordering. Compare the nut against your existing valve cover hardware.
What’s included
The package contains the nut only. Check the package contents against your installation before starting.









