Overview
The Omix-ADA standard shift flywheel, part 16912.05, is made for the AMC 258 6-cylinder engine. It fits 1982–1987 Jeep Cherokee (SJ), CJ5, CJ7, Scrambler, Wagoneer (SJ), J10 and Wrangler (YJ) models.
It is a standard shift flywheel, meant for manual transmissions. It is for the AMC 258 6-cylinder only, so confirm that your engine matches before ordering.
Key features
- Standard shift flywheel for manual transmissions
- For the AMC 258 6-cylinder engine
- Presented as a direct OE replacement
- Covers eight model entries from 1982 to 1987.
Flywheel surface and clutch wear
The flywheel gives the clutch disc a flat friction surface, and the pressure plate clamps the disc against it. Over time that surface can glaze from heat, develop scoring from a worn disc, or warp from overheating. Any of these conditions can cause slipping, chatter or a clutch that is hard to engage, so the flywheel should be judged as part of the whole clutch assembly.
Because the transmission and clutch must come out for flywheel work, it is practical to replace the clutch disc, pressure plate and release bearing at the same time. Inspect the ring gear teeth as well, since the starter engages them. Tighten the flywheel bolts to the specified torque and in a crisscross pattern.
- Look for glazing, scoring or heat discoloration
- Check ring gear teeth for chips or wear
- Confirm the crankshaft rear seal is not leaking
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16912.05 |
| UPC | 804314027742 |
| Product type | Standard shift flywheel |
| Engine | AMC 258 6-cylinder |
| Transmission | Standard shift (manual) |
Vehicle fitment
It fits the 1982–1983 Jeep Cherokee (SJ), the 1982–1983 CJ5, the 1982–1986 CJ7, the 1984–1986 Grand Wagoneer (SJ), the 1982–1987 J10, the 1982–1985 Scrambler, the 1982–1983 Wagoneer (SJ) and the 1987 Wrangler (YJ).
The Cherokee SJ and Wagoneer SJ are listed only for 1982–1983, and the Wrangler YJ only for 1987. Years and models not named here are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Flywheel work requires the transmission and clutch to come out first. If the clutch is due for replacement, do it at the same time, since the clutch disc and pressure plate bear on this surface.
What’s included
Check the package contents against your installation before starting, including clutch parts and bolts.









