Overview
The Jeep flywheel assembly, part 4666102AA, is a factory original equipment flywheel for the 2008 and 2011 Jeep Wrangler (JK). It is made for 2-door and 4-door models with the 3.8L engine and a manual transmission.
It is a direct replacement for the stock flywheel, so it suits an owner who wants the factory unit back in place rather than an aftermarket flywheel.
Key features
- Factory original equipment flywheel
- Direct replacement for the stock unit
- For manual-transmission models
- For the 3.8L engine
- Covers 2-door and 4-door Wrangler JK models
Before you swap a flywheel
A flywheel swap is a bigger job than the part itself suggests, because the transmission and clutch must come out first. Once the drivetrain is apart, the clutch disc, pressure plate and pilot bearing are all exposed, so it makes sense to inspect them at the same time rather than reassembling worn parts against a new flywheel.
The flywheel face should be smooth and free of heat marks, cracks or deep scoring. Clean any oil from the surface and keep fingers off the friction area. Use the correct bolts and tighten them in a crisscross pattern using the service procedure for your vehicle.
- Inspect the clutch disc for glazing or uneven wear
- Check the pressure plate springs and fingers
- Replace the pilot bearing if it feels rough
Specifications
| Brand | Jeep |
|---|---|
| Part number | 4666102AA |
| UPC | 70000633405 |
| Product type | Flywheel assembly |
| Transmission | Manual |
| Engine | 3.8L |
| Body | 2-door and 4-door |
Vehicle fitment
It fits the 2008 and 2011 Jeep Wrangler (JK).
Only 2008 and 2011 are named, so other Wrangler JK years and other Jeep models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a flywheel means removing the transmission and clutch first, so inspect the clutch disc, pressure plate and pilot bearing at the same time.
What’s included
One flywheel assembly. Confirm whether bolts or clutch parts are needed before starting the job.









