Overview
The Omix-ADA 12401.05 is a twist-in side marker light socket for the front or rear. It takes a 194 bulb, which is not included, and it fits the 1972 to 1986 Jeep CJ5, CJ6 and CJ7 and the 1981 to 1985 Scrambler.
It is a direct OE replacement Jeep part built to the original specifications, and it carries a limited five year warranty.
Key features
- Side marker light socket
- Front or rear
- Twist-in design
- Takes a 194 bulb (not included)
- Direct OE replacement design
- Covered by a limited five year warranty
Marker light wiring care
A side marker socket sits at the end of a small circuit, so its contacts take the brunt of heat, moisture and vibration. Corrosion on the contacts or in the housing is the most common cause of a dim or dead marker light, even when the bulb itself is good. Checking the socket is often quicker than tracing the wiring from the start.
When refitting, keep the socket seated firmly and make sure the ground path is clean and tight. Use dielectric grease on the contacts to slow corrosion, and route the wiring away from heat sources and moving parts. A marker light that flickers when the wiring is moved usually points to a loose connection, which is worth fixing before it starts to overheat.
- Check the ground connection at the lamp
- Replace a cracked lens gasket to keep water out
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 12401.05 (OAI12401.05) |
| UPC | 804314037178 |
| Part type | Side marker light socket |
| Position | Front or rear |
| Style | Twist in |
| Bulb | 194 bulb (not included) |
| Fit type | Direct fit |
| Warranty | Limited five year coverage |
Vehicle fitment
It fits the 1972 to 1983 Jeep CJ5, the 1972 to 1975 CJ6, the 1976 to 1986 CJ7 and the 1981 to 1985 Jeep Scrambler, in the Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade, SL and SR trims. Use part number 12401.05 and the UPC, when one is shown, to confirm you have the same item, because parts from the same brand can differ by vehicle, year or position.
The list does not include CJ5 and CJ6 models before 1972, or the CJ3. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Follow the installation steps for the vehicle, and torque all fasteners to the values for the model. Wire and fuse any electrical component correctly, and disconnect the battery before working on wiring. Check that the lamp works after installation, and check local regulations on marker lighting. Seal connectors against moisture and keep wiring away from heat and moving parts.
What’s included
- Side marker light socket
Not included: The 194 bulb is not included.









