Overview
The Omix-Ada 11811.28 is a push pin clip for the rocker molding on the Jeep Liberty KJ. It replaces OE 55157070AC and is a direct-fit part for the 2005 through 2007 Liberty (KJ).
The rocker molding is the trim strip along the lower side of the body, and this clip holds it in place with a push-in fit. Check the model year on your vehicle before ordering.
Key features
- Push pin clip for the rocker molding
- Replaces OE 55157070AC
- Direct fit for the 2005–2007 Jeep Liberty (KJ)
- Omix-Ada markets the part as meeting or exceeding OE standards
Rocker molding trim care
The rocker molding is the strip of trim along the lower edge of the body, and it takes a lot of road spray and debris. The push pin clips that hold it in place are exposed to the same conditions, so they can loosen or become brittle over the years. A loose molding often shows up first as a rattle or as a gap that collects dirt beneath the edge.
When a molding is reseated, clean the underside and the clip holes first so grit does not hold the trim away from the body. Press each clip evenly and check the molding runs straight along its length. Avoid high-pressure washing directly at the edges, since water can work behind the trim and loosen the clips further.
- Listen for rattles along the lower body
- Replace clips that crack when pressed
- Clean under the molding before reseating
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 11811.28 |
| Application | Rocker molding |
| Replaces | OE 55157070AC |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the following vehicle:
- 2005–2007 Jeep Liberty (KJ)
The 2002–2004 Liberty (KJ) and the 2008–2012 Liberty (KK) are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One push pin clip, part number 11811.28.










