Overview
The Crown Automotive Fender Flare Push Pin Retainer, part J4007117, holds front or rear fender flares in place and is sold individually. It fits the 1984–1994 Jeep Cherokee (XJ), the 2002–2012 Jeep Liberty (KJ), the 1997–2006 Jeep Wrangler (TJ), the 2007–2018 Jeep Wrangler (JK) and the 2018 Jeep Wrangler (JL).
It is also used on Wrangler models from 1997 on, which extends a little beyond the years above, so check your year before ordering.
Key features
- Holds front or rear fender flares
- Sold individually
- Fits the Cherokee XJ and Liberty KJ
- Fits Wrangler TJ, JK and JL
Fender flare fastening
Push pin retainers hold fender flares to the body with a snap-in grip, so they rely on clean holes and undamaged tabs to stay put. Flares move with suspension travel and trail vibration, which can work the retainers loose or crack the tabs over time. Checking them during routine service helps keep the flares from rattling or shifting.
When replacing a retainer, push it straight into the hole until it seats fully, and avoid forcing it at an angle. Look at the hole for rust, enlargement or cracks, since a worn hole will not hold a new retainer. Reseat the flare so it lies flat against the fender once the retainers are in.
- Replace retainers with cracked or missing tabs
- Clean and inspect the mounting holes
- Check flare alignment after reinstalling
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J4007117 |
| UPC | 848399062274 |
| Application | Front or rear fender flares |
| Quantity | Sold individually |
Vehicle fitment
Covered years run 1984–1994 for the Cherokee XJ, 2002–2012 for the Liberty KJ, 1997–2006 for the Wrangler TJ, 2007–2018 for the Wrangler JK and 2018 for the Wrangler JL.
Wrangler JL models from 2019 on, and Cherokee and Liberty years outside the ranges above, are not covered. Verify the year, model and trim against your vehicle before buying.









