Overview
The Omix-ADA 12031.02 is a hood to fender bumper grommet for Jeep vehicles. It is the rubber bumper that sits where the hood meets the fender. It is a direct OE replacement design, and one is needed per fender.
Key features
- Direct OE replacement design by Omix-Ada
- One required per fender
- Hood to fender mounting position
- Jeep application
Replacing a worn grommet
A hood to fender bumper grommet is the small rubber cushion that stops the hood from contacting the fender when it closes. Over time the rubber can flatten, crack or tear, which lets metal contact metal and causes rattles. Replacing it is a simple job that usually needs basic hand tools and a few minutes per side. Before removing the old grommet, note its position and any shim or spacer behind it so the new one sits at the same height.
When choosing a replacement, compare the shape, thickness and mounting style with the old grommet rather than relying on memory. Hood alignment affects how much the rubber compresses, so a grommet that is too thick can hold the hood high while one that is too thin lets it rattle. If the hood still rattles after replacement, check the latch and hinge bolts before replacing more parts. Clean the mounting area so the new grommet seats fully.
- Check the old grommet for flattening or cracking
- Inspect the hood latch for wear
- Clean the mounting surface before fitting
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12031.02 |
| UPC | 804314028930 |
| Quantity | One required per fender |
| Warranty | Limited five-year warranty. |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering. This grommet is offered for Jeep vehicles generally, so match it to the Jeep you own before installing.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Each fender needs one grommet. Check the package contents against your installation before starting.












