Overview
The Omix-ADA Grille to Hood Bumper, part number 12031.01, is a direct OE replacement bumper for the 1987–1995 Jeep Wrangler (YJ). It is made to the original specifications for owners restoring or repairing a YJ.
This direct OE replacement Jeep part carries a limited five year warranty.
Key features
- Direct OE replacement built to original specifications
- Grille to hood bumper
- Direct-fit design
- Limited five year warranty.
Restoring a YJ front end
A grille to hood bumper sits in front of the grille and below the hood edge, and it takes the first hit from brush and debris on the trail. Because it is bolted into the front sheet metal, its mounting points carry stress every time the hood is opened and closed. Check the brackets and hardware before fitting a new bumper.
On a restored YJ, the bumper finish matters for appearance and for slowing rust on the steel underneath. Clean the area and remove loose paint before fitting, and touch up any bare spots once the bumper is mounted. Keep an eye on the surrounding metal near the mounts for early rust.
If your YJ has a different front end from the original, confirm the fit before buying so the bumper lines up with the grille and hood. Replacing the hardware with new fasteners at the same time is a practical step.
- Inspect the mounting brackets
- Clean rust before fitting
- Check hood clearance after install
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 12031.01 |
| UPC | 804314028923 |
| Part type | Grille to hood bumper |
| Fit type | Direct fit |
| Warranty | Limited five year |
Vehicle fitment
It fits the 1987–1995 Jeep Wrangler (YJ) across its trims.
The 1997–2006 Wrangler (TJ) and later models are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.









