Overview
It is a replacement door hinge pin cap nut, part number OAI11202.26, for 07-18 Wrangler JK and JKU models. It replaces OE 6511744AA.
Use two per door. The cap nut has M6 x 1.00 internal threads and a recessed T-50 Torx-style button head.
Key features
- Replaces OE 6511744AA
- M6 x 1.00 internal threads
- Recessed T-50 Torx-style button head
- Black stainless steel finish
- Two cap nuts per door
Door hinge pin care
The hinge pin cap nut sits on the end of the hinge pin and keeps the pin from backing out. Because it is exposed, it takes road salt, water and trail grit, so a black stainless finish is useful but still needs occasional cleaning with a mild soap.
When the nut is removed, inspect the hinge pin for wear and check its threads for damage before fitting a new cap nut. Hinge bushings and door alignment are often checked at the same time, since a loose door can make the pin wear faster. Keep spares on hand, since a stripped recess is easier to avoid than to fix in the middle of a job.
- Use a Torx bit that fully seats in the recess
- Hand start the cap nut to avoid cross-threading
- Check door alignment after the pin is seated
- Replace any nut with a stripped Torx recess
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI11202.26 |
| Finish | Black stainless steel |
| Thread | M6 x 1.00 internal |
| Drive style | Recessed T-50 Torx-style button head |
| OE replaced | 6511744AA |
| Quantity per door | 2 |
Vehicle fitment
It fits 07-18 Wrangler JK and JKU models, which covers the 2007 to 2018 Jeep Wrangler JK range. Check your trim and door hardware before ordering.
It is for JK and JKU models only, so Wrangler TJ and JL generations are outside this fit. Confirm your year, model and trim before ordering.
Installation notes
The head is a T-50 Torx-style design, so keep a matching Torx bit on hand. Plan on two per door.
What’s included
Each package contains one cap nut, so buy two for each door.












