Overview
The Omix-Ada Targa top mounting knob is a replacement knob for 07-17 Jeep Wrangler JK and JKU models with the factory hardtop. It replaces OE part 1CJ57DX9AD.
Omix-Ada says its replacement parts meet or exceed OE standards for fit and reliable performance.
Key features
- Replacement for OE 1CJ57DX9AD
- Fits 07-17 Jeep Wrangler JK and JKU with factory hardtop
- It is a direct fit for 07-17 Jeep Wrangler JK and JKU models with a factory hardtop.
- It is designed to match the fit and performance expected of an original part.
Hardtop mounting hardware
The mounting knob holds the hardtop’s fastening point in place, so it carries repeated loading each time the top is set or removed. Plastic knobs can crack over time, especially in cold weather, while metal threads can strip if the knob is forced. Inspect the threads, the knob body and the surface beneath it whenever the hardtop is off for service.
When replacing the knob, clean the mounting surface and confirm the knob turns freely before tightening. Rubber gaskets and seals around the mounting point should sit flat, because a gap there lets water and wind noise into the cabin. A knob that spins without holding, or a hardtop that shifts when pressed, is a sign the part needs attention before the next trip.
Specifications
| Brand | Omix-Ada |
|---|---|
| UPC | 804314290207 |
| Part type | Targa top mounting knob |
| Replaces OE | 1CJ57DX9AD |
| Fits | 07-17 Jeep Wrangler JK / JKU with factory hardtop |
| Fit | Direct fit |
Vehicle fitment
It fits 07-17 Jeep Wrangler JK and JKU models equipped with the factory hardtop. Other Wrangler generations are not covered, and models without a factory hardtop are not covered.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
It is a single replacement knob.
















