Overview
The Omix-Ada headlight retaining ring replaces a damaged or aging ring on the 2007 to 2017 Jeep Wrangler JK, Rubicon and Unlimited. It is sold for either the left or right headlight, driver or passenger side.
It is built to OE standards and uses the factory hardware. It fits 2 and 4-door models.
Key features
- Replacement for damaged or aging retaining rings
- Built to OE standards for a fit using factory hardware
- Works on left or right headlights
- Fits 2 and 4-door models.
Headlight ring replacement tips
The headlight retaining ring holds the lamp in the housing and keeps it aligned with the beam pattern. When it is cracked, warped or missing, the headlight can shift, rattle or work loose, which changes where the beam points.
Before removing the old ring, note its position and the orientation of any tabs so the new one seats the same way. Clean the housing lip and check the factory hardware for corrosion. Reusing rusted or stripped fasteners can make the new ring feel loose even when it is correct.
Headlight aim should be checked after the ring is installed, especially if the lamp was moved during the job. Driving over rough trails or through washes can knock a lamp out of alignment, so inspect the ring and mounts at routine service intervals.
- Note tab orientation before removing the old ring
- Clean the housing lip before fitting
- Recheck headlight aim after installation
Specifications
| Brand | Omix-Ada |
|---|---|
| UPC | 804314291242 |
| Fitment years | 2007-2017 (Wrangler JK) |
| Side | Driver or passenger |
| Quantity | One, listed individually |
Vehicle fitment
It fits 2007 to 2017 Wrangler JK, Rubicon and Unlimited models. Wrangler TJ and LJ models, and JL models from 2018 on, fall outside these years.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The ring is designed to use the factory hardware. Check that the ring matches the headlight side you are replacing.
What’s included
One headlight retaining ring, listed individually.
Not included: The ring uses the factory hardware, so keep your existing fasteners ready before installation.


















