Overview
The Omix-Ada 11606.01 is a seven-inch fender flare kit for the 1976–1986 Jeep CJ7. It carries part number OAI11606.01 and comes as a set of four with 7 inches of width and coverage. The kit is paintable.
The flares are made of UV-treated thermoplastic that Omix-Ada describes as durable and built for years of service. Each replacement flare is designed to fit the factory mounting holes, although some models may need hole relocation or hole modification where the factory hardware is rusted.
Unlike the factory-width kits, this one requires more work. The rear wheel openings must be trimmed, and some drilling is needed. The mounting hardware is not included, so plan to use the factory hardware or separately sourced fasteners.
Key features
- Seven inches of width/coverage
- Set of four flares
- UV-treated thermoplastic construction
- Paintable finish
- Rear wheel openings require trimming
Wider flares on an older body
Wider flares on a CJ7 change how much of the tire is covered, and they also change how much room the tire has at the inner fender. Before installing, check the mounting points on the body and the area where the flare edge meets the fender. Older bodies can have soft or rusted metal around the wheel openings, so inspect and treat that metal before fitting the flares.
Because the rear wheel openings require trimming with this kit, plan each cut carefully and check tire clearance at full steering lock. Drilling adds new holes that need sealing against moisture, so use a primer on cut edges and bare metal. Recheck all fasteners after the first few trail runs, since loose hardware is a common cause of rattles and rubbing on wider setups.
- Mark trim lines before cutting
- Prime all cut and drilled edges
- Check steering lock clearance after mounting
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 11606.01 (also written as OAI11606.01) |
| UPC | 804314117313 |
| Quantity | Set of 4 |
| Width/coverage | 7 inches |
| Finish | Paintable |
| Material | UV-treated thermoplastic |
| Hardware | Not included |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1976–1986 Jeep CJ7 in the Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade trims.
This kit is made for the CJ7 only. Compare your year, model and trim before placing an order.
Installation notes
The rear wheel openings must be trimmed to fit this kit, and some drilling is required. Hardware is not included, so the factory hardware or separately sourced fasteners will be needed.
What’s included
A set of four seven-inch fender flares.
Not included: Mounting hardware.









