Overview
The MSD Wiring Harness Cable, part number MSD8860, is a cable for connecting ignition components. It is offered in different lengths and falls in the ignition wire harness category.
The fitment is Universal Fit. Measure the run and confirm the connector type and the components it joins against your own ignition system before buying.
Key features
- Connects ignition components
- Offered in different lengths
- Listed in the ignition wire harness category
- Fitment attribute: Universal Fit
Routing and connector care
A wiring harness cable sits in an engine bay that brings heat, vibration and road spray. Route the run away from exhaust parts and moving linkage, and use clips or split loom to keep it from rubbing. Leave a small amount of slack so the cable does not pull at its connectors when the engine moves.
Connectors are the most common failure point in ignition wiring. Keep them dry, clean any corrosion from the terminals, and use a light dielectric grease on sealed connectors to slow moisture entry. Seat each connector fully and check that the locking tab engages.
Before installing a new run, measure the route twice and label each end. Good labels make later service faster and help avoid swapping connections that look alike.
Specifications
| Brand | MSD |
|---|---|
| Part number | MSD8860 |
| Length options | Different lengths offered (no figures stated) |
| Fitment attribute | Universal Fit |
Vehicle fitment
No vehicle, year or engine is named. Universal Fit is the only fitment attribute, so match the cable length and connections to your own ignition components.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package for connectors, terminals and mounting hardware before starting the install.









