Overview
The Spyder Auto Group 5080950 is a set of LED crystal headlights for the 2007–2015 Jeep Wrangler (JK). It fits the 70th Anniversary, Rubicon, Sahara, Sport and X trims, plus the Unlimited versions of those trims. It is built for plug-and-play fitment and comes with T10 LED bulbs.
Key features
- Crystal headlight styling
- Uses T10 LED bulbs
- T10 LED bulbs are included.
- Designed for plug-and-play fitment
Before you install LED crystal headlights
LED headlights place a new light source inside an existing housing, so the beam pattern depends on how well the LED sits in the reflector. Before installing, inspect the old bulb sockets for corrosion and make sure each connector latches fully. A poor connection can cause flicker or a dead lamp, so check the harness for worn insulation.
Crystal housings on Wranglers are often exposed to road spray and trail debris. Seal any gap at the rear cover and keep the vent dry. After the first week of driving, check aim against a flat wall, since a shift in the mounting bracket can change beam direction.
- Test each bulb before final assembly
- Inspect connectors for corrosion
- Recheck aim after the first week
Specifications
| Brand | Spyder Auto Group |
|---|---|
| Part number | 5080950 |
| UPC | 847245080950 |
| Bulb type | T10 LED |
| Lamp style | LED crystal |
| Bulbs | Included |
Vehicle fitment
Spyder Auto Group lists these headlights for the 2007–2015 Jeep Wrangler (JK) in the 70th Anniversary, Rubicon, Sahara, Sport and X trims, including the Unlimited 70th Anniversary, Unlimited Rubicon, Unlimited Sahara, Unlimited Sport and Unlimited X versions.
Wrangler JK model years 2016–2018 are not on the manufacturer list, and the Wrangler JL generation from 2018 onward is a separate design that is not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plug-and-play fitment requires no drilling or cutting. Disconnect the battery before replacing the headlamps.
What’s included
The set includes LED bulbs. Confirm the number of headlights in the set against your installation before starting.









