Overview
The Jeep pinion oil slinger, part JEP68004073AA, is a factory replacement slinger for the pinion of the front axle. It fits 2007–2018 Jeep Wrangler JK models, in both two-door and four-door body styles.
The oil slinger throws lubricant around the pinion area to keep the bearings and seals fed. It fits the model 44/266 and model 30/186 front axles.
Key features
- Factory replacement part from Jeep
- Fits the model 44/266 front axle
- Fits the model 30/186 front axle
- Part number JEP68004073AA
Axle work and the pinion seal
The pinion slinger sits behind the pinion yoke, so most of the work on it is done while the yoke is off. Removing the yoke also gives access to the pinion seal, which is commonly replaced at the same time if it shows leakage or wear. Check the yoke splines and the pinion nut threads for damage before reinstalling them.
Lubricant that leaks past the pinion seal can end up on the slinger and in the bearings, so look for gear oil residue around the pinion area during inspection. Mark the pinion nut and yoke alignment before removal, and keep the axle gear oil at the correct level. Because the slinger works by throwing oil, it does its job only when the seals and bearings are in good order.
Specifications
| Brand | Jeep |
|---|---|
| Part number | JEP68004073AA |
| Component | Pinion oil slinger |
| Front axle | Model 44/266 or model 30/186 |
Vehicle fitment
It fits 2007–2018 Wrangler (JK) models, both two-door and four-door, with the model 44/266 or model 30/186 front axle.
Wranglers from 2018 on, such as the JL, are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replacing the slinger means removing the pinion yoke, which also gives access to the pinion seal. Check the pinion nut torque when reassembling the front axle.
What’s included
One pinion oil slinger.









