Overview
The Hypertech Speedometer Calibrator, part number 752504, is a plug-in device that recalibrates the speedometer and odometer for non-stock tire sizes and non-stock rear gear ratios. It fits 2018 and later Jeep Wrangler JL 2 and 4 door models, and 2018 and later Ram 1500, 2500 and 3500 trucks.
The unit reads, displays and clears diagnostic trouble codes. It connects to the vehicle’s under-dash connector and reprograms the vehicle computer in a matter of minutes. It works with gas and diesel engines and can return the vehicle to factory settings.
The kit includes a USB cable and a CD with software for internet updates. An optional internet upgrade adds the full set of calibrator features for each vehicle. The unit corrects for tire sizes from 24 inch to 40 inch in .25 inch increments, and up to 54 inches depending on the application. Check your tire size against both figures before ordering.
Key features
- Corrects speedometer and odometer for non-stock tire sizes and rear gear ratios
- Reads, displays and clears diagnostic trouble codes
- Internet updatable with the included USB cable and CD software
- Option to return the vehicle to factory settings
- Works with gas and diesel engines.
- Installs in minutes.
Before you buy
Changing tire diameter or rear gear ratio shifts the speed the vehicle computer reports, so the speedometer and odometer read differently from actual travel. A calibrator adjusts those readings to match the new setup. Before buying, measure the tire you plan to run, since the correction only works within the size range the unit supports. Confirm which gear ratio is installed in the axle, because a mismatch leads to inaccurate readings.
Calibration does not change engine output, and it is usually paired with other changes such as larger tires, lift components or regearing. If the tires change again later, recalibrate to the new size. Fuel economy and transmission shift timing can also feel different after a tire change, so note how the vehicle behaves on the first drives.
- Confirm tire diameter after any suspension lift
- Recalibrate after each tire or gear change
- Keep the USB cable and software for later updates
- Note the original readings before making changes
Specifications
| Brand | Hypertech |
|---|---|
| Part number | 752504 |
| UPC | 700008538981 |
| Tire size range | 24 inch to 40 inch, in .25 inch increments |
| Tire size maximum | Up to 54 inch, depending on application |
| Gear ratio correction | Yes |
| Diagnostic trouble codes | Reads, displays and clears |
| Engines | Gas and diesel |
| Included | USB cable and CD with software |
Vehicle fitment
It fits 2018 and later Jeep Wrangler JL 2 and 4 door models and 2018 and later Ram 1500, 2500 and 3500 trucks.
Earlier Wrangler generations such as the TJ and JK are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Plug the unit into the under-dash connector, select the new tire height or new rear gear ratio, and let the device reprogram the vehicle computer. This takes a matter of minutes.












