Overview
The Go Rhino BR10 24219T is a one-piece front replacement bumper in textured black, made from 1/4 inch thick steel. It allows lights and a winch to be installed.
Optional 3 x 3 inch lights are available separately. A framed mesh vent cover hides the mounting bracket while allowing airflow to the vehicle, and functional, removable steel mesh covers add protection and airflow for the winch. Complete installation requires the BR10 Winch Tray, part number ORP24473TW. Go Rhino says drilling may be required depending on the year of the vehicle.
Key features
- One-piece bumper from 1/4 inch thick steel
- Textured black finish
- Optional 3 x 3 inch lights
- Framed mesh vent cover over the mounting bracket for airflow
- Removable steel mesh covers protect the winch and increase airflow
- Drilling may be required depending on the vehicle’s year
Planning a winch installation
A winch bumper changes the weight and balance of the front end, so think about the full setup before ordering. Choose a winch rated for the load you expect to pull, and make sure the mounting plate and bumper hold it securely. Lights and a winch often need separate wiring, so plan the harness route early.
Steel bumpers protect the radiator and grille area in rocks and brush, but added weight can change steering and braking feel. Recheck bolts and mounting hardware after the first few trail runs, and inspect the bumper for cracks or bent corners after a hard hit. Keep recovery shackles and straps rated above the winch line pull you expect to use.
- Match the winch to your expected load
- Route lighting and winch wiring together
- Inspect bolts and corners after impacts
Specifications
| Brand | Go Rhino |
|---|---|
| Part number | 24219T |
| UPC | 887753086990 |
| Series | BR10 front replacement bumper |
| Material | Steel, 1/4 inch thick |
| Finish | Textured black |
| Construction | One piece |
| Optional lights | 3 x 3 inch, sold separately |
| Required winch tray | BR10 Winch Tray ORP24473TW |
| Vehicle | Trucks; make, model and years not stated |
Vehicle fitment
It fits trucks. Drilling needs vary with the vehicle’s year, so confirm fit for your vehicle’s year, model and trim before ordering.
Drilling needs depend on the year of the vehicle. Confirm your vehicle’s year, model and trim before ordering, and plan for the drilling the install requires.
Installation notes
Drilling may be required depending on the year of the vehicle. The BR10 Winch Tray ORP24473TW is required to complete the installation.
What’s included
- BR10 front replacement bumper
- Framed mesh vent cover
- Removable steel mesh covers
Not included: the BR10 Winch Tray ORP24473TW and the optional 3 x 3 inch lights.








