Overview
The Flowmaster FLW717872 is a FlowFX cat-back exhaust system for the 2009–2014 Ford F-150, with dual 2.50-inch tailpipes that exit on each side behind the rear wheels. The manufacturer fitment list covers 2009–2014 F-150 trucks in the FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, Platinum, STX, XL and XLT trims.
The system is built from 409S stainless steel throughout. A 3.00-inch inlet pipe feeds a FlowFX straight-through muffler with a single inlet and dual outlets. Dual 4.50-inch black ceramic coated 304S stainless steel tips finish the rear and give the truck a custom look that pairs with the FlowFX tone.
It fits 2 and 4 wheel drive trucks with all wheelbases. The tailpipes angle out behind the rear wheels, which directs exhaust away from a boat or travel trailer when towing.
Key features
- 409S stainless steel throughout the system
- 3.00-inch inlet pipe into a FlowFX straight-through muffler
- Dual 2.50-inch mandrel-bent stainless tailpipes exiting at the sides
- Dual 4.50-inch black ceramic coated 304S stainless steel tips
- Uses the factory hanger locations, with an additional hanger for the left side tailpipe
- Fits 2 and 4 wheel drive trucks and all wheelbases
Before you install
A cat-back system replaces the piping from behind the catalytic converter to the tailpipe ends, so the factory pipes ahead of it stay in place. Before the work starts, inspect the factory hangers, clamps and heat shields. Worn rubber hangers allow pipes to contact the body and cause rattles, so replacing them while the old system is off is a practical step.
Stainless steel holds up well to road salt, but the joints and welds still need periodic checks. After installation, start the engine and listen for leaks near the flanges, then tighten clamps once the system has warmed and settled. Dual side tailpipes sit close to the rear wheels, so make sure they clear the tires through full suspension travel and do not contact the body or trailer hitch.
- Check hangers and heat shields before removing the old system
- Tighten clamps after the first few drives
- Confirm tail tip clearance at the rear wheels
Specifications
| Brand | Flowmaster Exhaust |
|---|---|
| Part number | FLW717872 |
| System type | Cat-back |
| Inlet pipe | 3.00-inch |
| Muffler | FlowFX straight-through, single inlet/dual outlet |
| Tailpipes | Dual 2.50-inch mandrel-bent stainless steel |
| Tips | Dual 4.50-inch diameter, black ceramic coated 304S stainless steel |
| Material | 409S stainless steel throughout |
| Exit location | Dual side |
| Drive and wheelbase | 2 and 4 wheel drive, all wheelbases |
| Fitment type | Direct fit |
Vehicle fitment
Fitment covers 2009–2014 Ford F-150 trucks in the FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Limited, Platinum, STX, XL and XLT trims. The kit is designed for both 2 and 4 wheel drive trucks.
Model years outside 2009–2014 are not covered, and other Ford trucks are not included. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The additional hanger supports the new left side tailpipe, and it works alongside the factory hanger locations the system reuses.
What’s included
The kit includes the FlowFX muffler, both mandrel-bent tailpipes, the pair of 4.50-inch tips, the additional hanger, detailed installation instructions and every needed fastener.
















