Overview
The Flex-A-Lite FLX107006 is an adjustable temperature electric fan controller for 12-volt systems. It turns the electric fan on and off at a temperature you set with a dial, which adjusts the activation point between approximately 180 and 240 degrees Fahrenheit.
Flex-A-Lite marks the FLX107006 as universal fit, so it is not built for one specific vehicle. It carries a 20 amp rating and is intended for 12-volt systems only.
Key features
- Dial adjusts the fan activation temperature between approximately 180 and 240 degrees Fahrenheit
- Turns the electric fan on and off at the selected temperature
- 20 amp rating
- Intended for 12-volt systems only
Matching the fan and controller
A fan controller decides when the cooling fan runs, so its job is to keep the engine from overheating at idle and in slow traffic while avoiding unnecessary fan noise on the highway. Setting the activation point is a balance: a lower point runs the fan sooner and more often, while a higher point lets the engine run warmer before the fan starts. Start with a mid-range setting and adjust it after watching the temperature gauge over a few drives.
Before wiring, confirm the fan draws current that the controller and its fused relay can handle. Heavy-gauge wiring with clean, solid ground connections prevents voltage drop that can make a fan run weakly. Keep the sensor and harness away from exhaust heat and moving parts, and route the wiring so it cannot rub against the fan blades.
- Mount the controller where it stays dry and away from engine heat
- Use a fused relay sized for the fan load
- Recheck ground connections for corrosion each season
Specifications
| Brand | Flex-A-Lite |
|---|---|
| Part number | FLX107006 |
| Activation temperature | Adjustable, approximately 180 to 240 degrees Fahrenheit |
| Current rating | 20 amp |
| Voltage system | 12-volt only |
Vehicle fitment
This controller is universal fit, so it is not vehicle-specific and no year, make, model or trim is stated. Confirm that your electric fan and cooling system run on a 12-volt system before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The controller switches the fan on and off, so wire it through a fused relay and set the dial after installation. Disconnect the battery before wiring the controller to the fan circuit.
What’s included
Check the package contents against your installation before starting.


![Flex-A-Lite Electric Fan Motor Replacement For PN[394] - 30312](https://slickrock4x4.com/wp-content/images/30312-Flex-1-1-300x300.jpg)






