Overview
The Fabtech FABFTS24248 is a rear steel tube fender for the 2020–2026 Jeep Gladiator, finished in textured black. It is designed to allow oversized tires for off-road use while adding protection, and it bolts into the factory fender mounting holes.
The rear fender measures 4.5 inches wide, which Fabtech describes as narrow compared with the factory fender. It is constructed of 1.50 OD x .095 wall steel tubing with a .060 thick steel top plate, which Fabtech says helps the fender withstand large objects striking it on rough trails.
The Gladiator tube fenders are American made, with a textured black powdercoat finish. Installation requires no cutting or drilling, which keeps the fitting work to bolting the fender in place.
Key features
- Replaces the factory rear fenders in the same mounting holes.
- Narrow rear design, measuring 4.5 inches wide.
- 1.50 OD x .095 wall steel tubing with a .060 thick steel top plate.
- Textured black powdercoat finish.
- No cutting or drilling required.
Gladiator rear tire room
A rear tube fender on a Gladiator helps protect the bed side and rear corner from brush, trail debris and rock strikes. Oversized tires need clearance at the top of the wheel well and along the fender edge, so fit depends on tire width and suspension height. Measure the gap before final tightening, since a small shift in the mount can change clearance on one side.
Because installation bolts into the existing mounts, the fenders are easy to remove for service. Inspect the top plate and tubing after rough trail use, and look for dents near the mounting points. Keep the textured black finish clean and touch up chips before rust starts. Fasteners should be checked after the first several trail runs.
- Measure clearance on both sides
- Inspect the top plate after rough trail use
- Touch up powdercoat chips early
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FABFTS24248 |
| Location | Rear |
| Type | Tube fender |
| Tubing | 1.50 OD x .095 wall steel |
| Top plate | .060 thick steel |
| Rear width | 4.5 inches |
| Finish | Textured black |
| Installation type | No cutting or drilling required |
| Fitment type | Direct fit |
| Origin | American made |
Vehicle fitment
The manufacturer list covers 2020–2026 Jeep Gladiator trims: 80th Anniversary, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport.
The Gladiator Altitude trim is not on the list, and Wrangler models are not covered by this part. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the mounting hardware and fender count against your installation before starting.













