Overview
The Daystar Firewall Electrical Boot, product code KU20040BK, is a black poly grommet that seats in a drilled firewall hole. It protects wiring from the sharp edges of the firewall. It is a universal design, so no vehicle is named for it.
The boot pops into place like a rubber grommet and can be trimmed to fit a range of wire thicknesses.
Key features
- Universal design that pops into place like a rubber grommet
- Can be trimmed to suit a variety of wire thicknesses
- Black poly construction
- Installs in a 1.25 hole drilled through the firewall
Sealing the firewall pass-through
A firewall pass-through keeps wiring from rubbing on sheet metal edges, and it keeps heat, road spray and engine noise out of the cabin. A rubber or poly boot does its job only when it seats fully and grips the wire bundle. A loose boot lets the wires shift and wear through insulation over time.
Before drilling, check the far side of the firewall for brake lines, harnesses, heater hoses and mounting brackets. Deburr the hole so the edge does not cut the boot. If the bundle is thick, trim the boot in small steps rather than cutting too much at once, since an oversized opening lets water and fumes through.
- Check the far side of the firewall before drilling
- Deburr the hole edge before fitting the boot
- Replace a cracked or hardened boot
Specifications
| Brand | Daystar |
|---|---|
| Product code | KU20040BK |
| UPC | 618089002022 |
| Material | Black poly |
| Design | Universal |
| Quantity | One boot (individual item) |
Vehicle fitment
This boot is universal and is not vehicle-specific. Its fit depends on the firewall opening you drill, so measure the location and check that it clears components on your vehicle before drilling.
Installation notes
Drill the 1.25 hole, press the boot into place, trim it to fit the wires, run the wires, and secure the boot with a zip-tie. Wear eye protection while drilling the firewall.









