Overview
The Curt Manufacturing CRT42178 is a chrome switch ball with a 1-7/8 x 2 size and a 1-inch shank hole. Curt says these balls can be removed and changed out without removing the center post.
Two weight ratings appear for this ball: 3,500 LBS and 6000lbs. Confirm which rating applies before towing.
Key features
- Removable balls that change without taking off the center post
- 1-7/8 x 2 inch size listing
- 1-inch shank hole
- 3,500 LBS weight rating in the specifications
- Chrome finish
Swapping ball sizes on the mount
Removable switch balls make it possible to change size on the mount in place. Before swapping, confirm the trailer is unhitched and the tow vehicle is parked on level ground. Loosen the retaining nut, lift the old ball off the shank, and seat the new ball so its flange sits flat. Tighten the nut to the torque shown on the packaging, then check that the ball does not rock by hand.
Clean the shank and ball contact faces before each change, since grit can keep the ball from seating. Inspect the ball’s threads and surface for wear, and keep spare nuts with the set. If the trailer weight is close to the rating, check the rating before each tow rather than assuming the ball will hold.
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT42178 |
| Size (inches) | 1-7/8 x 2 |
| Weight rating | 3,500 LBS |
| Shank hole size | 1 inch |
| Finish | Chrome |
Vehicle fitment
It is a universal fit, so it is not built for one vehicle. Your mount and trailer setup decide compatibility.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The balls are removed and swapped without taking out the center post, so the size can be changed on the mount in place.









