Overview
The Curt Manufacturing 45405 is a reducer sleeve adapter for trailer hitches that converts a 2-1/2 x 2-1/2 inch receiver tube opening to a 2 x 2 inch opening, so a 2 inch ball mount shank can be used in a 2-1/2 inch receiver. It is universal fit, so compatibility depends on receiver tube size rather than a specific vehicle. It works with 2-1/2 x 2-1/2 inch receiver tubes.
Hitch adapters like this one solve a common towing mismatch, where a ball mount shank is too small or too large for the receiver tube. Curt’s adapter line covers receiver tube openings and shanks of 1-1/4, 2 and 2-1/2 inch dimensions, and the adapters come in several lengths to give more clearance for a cargo carrier, bike rack or spare tire. This model is the reducer sleeve for the 2-1/2 inch to 2 inch step.
Key features
- Reduces a 2-1/2 x 2-1/2 inch receiver tube opening to a 2 x 2 inch opening
- Designed for installation in a 2-1/2 x 2-1/2 inch hitch.
- Formed on CNC equipment and welded together with advanced robotic systems
- Every surface is mechanically descaled so the sleeve is smooth enough to accept a finishing coat
- Black carbide powder coat finish designed for rust, chip and UV resistance
- Gross trailer weight and tongue weight capacity are limited to the hitch it is installed in
Matching shank and receiver
A reducer sleeve is only as good as the fit between the receiver tube and the shank. Measure the receiver opening with the sleeve in mind, then measure the ball mount shank it will hold. Sleeves that are a little loose can rattle and wear the tube, so a snug fit matters more than the shank alone.
Check the receiver’s rated weights before towing with an adapter, because the hitch sets the limits. Inspect the sleeve after the first few trips for scraping, bent edges or rust at the weld seams, and clean debris out of the tube so the sleeve seats fully. Replace a sleeve that cracks or deforms rather than bending it back.
- Measure the receiver tube opening before ordering
- Wipe grit from the tube before installing
- Recheck the pin fit after the first trips
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT45405 |
| Receiver tube opening | 2-1/2 x 2-1/2 inch |
| Opening after reduction | 2 x 2 inch |
| Finish | Black carbide powder coat |
| Fitment | Universal fit |
Vehicle fitment
This sleeve is universal fit and is not matched to specific vehicles. Fit depends on the receiver tube, which must be 2-1/2 x 2-1/2 inch for this reducer to install. Receiver size is usually measured at the tube opening, so measure that opening rather than relying on a vehicle model name.
Because the sleeve is universal fit, no vehicle year, model or trim list applies. Confirm your receiver tube size and your trailer’s weight needs before you install it.
Installation notes
The sleeve sits inside the receiver, so the gross trailer weight and tongue weight ratings that apply are those of the hitch, not the sleeve. Check the hitch rating against your trailer before towing.
What’s included
The package is a single reducer sleeve adapter. Check the package contents against your installation before starting.












