Overview
The Crown Automotive 53007978 is a water pump tube for the 1991 to 1992 Jeep Comanche (MJ) with the 4.0L engine. It is a direct fit replacement. Water pump tubes route coolant through the cooling system, so a correct fit is needed for a leak-free connection.
Crown Automotive makes replacement parts for Jeep vehicles. This tube covers only the 1991 and 1992 model years, so check the year and engine before fitting.
Key features
- Water pump tube, part 53007978
- Stated fit: 1991 to 1992 Jeep Comanche MJ with 4.0L engine
- Direct fit replacement part
- Replacement part from Crown Automotive
Before you install
A water pump tube carries coolant between the engine and the water pump, so both of its ends must seal against the hose connections. Over time the rubber seals and mounting faces can harden or corrode. A small weep at a joint often shows first as dried coolant residue around the fitting, so look there before removing the old tube.
When replacing the tube, the gasket or O-ring at each joint is usually renewed at the same time, and the clamps and hoses that connect to it are worth inspecting. After the job, refill and bleed the cooling system, watch the joints during the first warm-up, and check the coolant level again once the engine has cooled.
- Check both ends for dried coolant residue
- Renew seals or gaskets at the same time
- Inspect hoses and clamps for cracking
- Bleed air from the cooling system after refilling
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 53007978 |
| UPC | 848399018028 |
| Stated vehicle | 1991 to 1992 MJ Comanche |
| Engine | 4.0L |
| Fitment type | Direct fit |
Vehicle fitment
The tube fits the 1991 to 1992 MJ Comanche with the 4.0L engine.
Other Comanche years and engines are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
The tube is the only item included.
Not included: Gaskets, clamps and hoses are not included. Obtain them separately if your repair needs them.









