Overview
The Crown Automotive JA014709 is a U-bolt nut with a 1/2 inch to 20 thread. It fits the 1974–1983 Jeep CJ5, 1976–1986 Jeep CJ7, 1981–1985 Jeep Scrambler and 1987–1990 Jeep Wrangler (YJ).
The nut is a U-bolt fastener, so its thread must match the U-bolt it is used with. Check the 1/2 inch by 20 thread before fitting, and confirm the vehicle is one of those below.
Key features
- 1/2 inch to 20 thread
- Fits CJ5, CJ7, Scrambler and YJ Wrangler models
Choosing and fitting U-bolt nuts
A U-bolt nut clamps the axle or spring to the U-bolt, so the thread and seating surface must both be right. Thread mismatch makes a nut feel tight without holding properly, which can let the clamp loosen under load.
When fitting, clean the threads on the U-bolt and wipe the seating face of the nut. Tighten in an even pattern and recheck after the first drives, because clamp loads settle as the parts seat.
On these older Jeeps, U-bolts often corrode before the nuts do. Replace worn U-bolts with the nuts and check the spring pads, since a loose clamp can damage the spring center bolt and the axle housing.
- Check thread match before fitting
- Recheck clamp after first drives
- Inspect U-bolts for rust or stretched threads
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | JA014709 |
| UPC | 848399073423 |
| Thread size | 1/2 inch to 20 |
Vehicle fitment
It fits the 1974–1983 Jeep CJ5, 1976–1986 Jeep CJ7, 1981–1985 Jeep Scrambler and 1987–1990 Jeep Wrangler (YJ). Wrangler YJ years after 1990 and the Cherokee are not covered. Confirm your vehicle’s year, model and trim before ordering.
The Wrangler YJ fit runs only through 1990 for this nut.
Installation notes
Check the U-bolt thread is 1/2 inch to 20 before fitting, since a mismatched nut will not seat properly.
What’s included
One U-bolt nut only.









