Overview
The Crown Automotive 56027905 is a speed sensor, listed by Crown Automotive as a direct fit part. Crown Automotive is a maker and distributor of replacement parts for Jeep vehicles.
Speed sensor basics
A speed sensor reads the rotation of a gear, shaft or wheel and sends a signal that the vehicle uses for speed readings and related functions. When the signal drops out or becomes erratic, the speedometer may jump, stall or stop reading, and transmission shifting can behave oddly in some vehicles.
Replacing a speed sensor is usually straightforward, but the sensor’s position and air gap matter. Clean the mounting surface, inspect the connector for corrosion and check that the new sensor seats fully. A sensor that sits off its mount can read inaccurately even when it is new.
Speed sensors are often replaced alongside their wiring harness or connector if those show wear. Keep a note of the original routing and clip positions, and secure the wiring away from heat and moving parts. Clear any stored fault codes after the repair and test the speedometer on a short drive.
- Inspect the connector for corrosion
- Confirm the sensor seats fully on its mount
- Clear stored fault codes after the repair
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 56027905 |
| UPC | 848399022544 |
| Part type | Speed sensor |
Vehicle fitment
Confirm the sensor matches your vehicle’s year, model and engine before ordering. It is a direct fit part, so check the part number against the existing sensor.
Confirm your vehicle’s year, model and trim before ordering.









