Overview
The Crown Automotive 4854033 is an accessory drive serpentine belt for 4.0L engines in left-hand-drive vehicles with air conditioning. It measures 88 inches with 6 ribs. It fits 2000–2004 Jeep Grand Cherokee (WJ) and 2000–2006 Jeep Wrangler (TJ) models.
Use it as a replacement belt on those models when the existing accessory drive belt is worn, after confirming the length matches.
Key features
- 88-inch length with 6 ribs
- Accessory drive belt for 4.0L engines
- Designed for left-hand-drive vehicles with air conditioning
- Fits WJ Grand Cherokee and TJ Wrangler models.
Checking belt routing
The 4854033 is made for left-hand-drive vehicles with air conditioning, so the belt routes around a different set of accessory pulleys than on a right-hand-drive setup. Before pulling the old belt, sketch or photograph the routing so the new belt follows the same path. A belt routed incorrectly can run off a pulley or loosen the compressor drive.
The 88-inch length matters on a 4.0L engine. A belt that is too short can stress the tensioner, and one that is too long can slip under load. Compare the length against the old belt with both laid flat, and check the rib count on each. Inspect the tensioner pulley and idler bearings while the belt is off, since they often wear alongside the belt.
- Photograph the belt routing before removal
- Check tensioner movement and spring tension
- Look for pulley grooves that are worn or glazed
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4854033 |
| UPC | 848399009163 |
| Part type | Serpentine belt |
| Belt position | Accessory drive |
| Engine | 4.0L |
| Length | 88 inches |
| Ribs | 6 |
| Drive configuration | Left-hand drive with A/C |
Vehicle fitment
It fits 2000–2004 Jeep Grand Cherokee (WJ) in Laredo, Limited, Special Edition and Sport trims, and 2000–2006 Jeep Wrangler (TJ) in 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X trims. The belt is also marked universal fit, so confirm the engine, length and rib count.
Grand Cherokee models outside 2000–2004 and Wrangler TJ models before 2000 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the 88-inch length and 6-rib count match your current belt before installing, since the belt routing on a left-hand-drive A/C engine must match the old one.
What’s included
Includes a serpentine belt.









