Overview
The Crown Automotive J3124570 is an outer bearing cup for transfer case output shaft bearing assemblies. A bearing cup is the outer race that the rollers run against, so the matching bearing is a separate part from this cup.
The part is identified by part number J3124570 and UPC 848399057782. It is a direct fit part.
Key features
- Outer race for transfer case output shaft bearings
- Outer cup only; the bearing rollers are a separate part
- Identified by part number J3124570
- It is a direct fit part for the transfer case output shaft bearing position.
Installing a bearing cup
A bearing cup sits in the case bore and gives the rollers a hard surface to run against, so its seat condition affects the life of the whole assembly. Before pressing a new cup in, clean the bore and check for scoring, cracks or a loose fit. A cup that sits crooked in its bore can load the rollers unevenly and cause early noise.
Use a driver that contacts the cup face evenly, and keep it square to the bore so the cup seats fully without damage. Check the rollers, cone and seal at the same time, since replacing only the cup can leave worn rollers behind. Confirm the bearing layout matches your transfer case before reassembly, because the cup must pair with the correct roller set.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3124570 |
| UPC | 848399057782 |
| Component | Outer bearing cup |
| Application | Transfer case output shaft bearing |
| Fitment type | Direct Fit |
Vehicle fitment
Fit depends on the transfer case and the bearing it runs with, so the setup on your unit decides whether it matches.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The outer bearing cup, part number J3124570.
Not included: the bearing rollers that run in the cup, which are a separate part.









