Overview
The Crown Automotive J0649712 is a 6 volt stock replacement ignition coil for Jeep Willys vehicles built from 1941 to 1958. It is a direct-fit replacement for CJ-3, CJ-5, CJ-6, FJ and Truck models.
Crown Automotive has been a manufacturer and distributor of replacement parts for Jeep vehicles for over 50 years. The company says its range includes many factory-discontinued items. This coil is offered under part number J0649712 with UPC 848399053104.
Key features
- 6 volt ignition coil
- Direct fit, stock replacement design
- Fitment list covers a long run of Willys models from 1941 to 1958
- Crown Automotive part number J0649712 with UPC 848399053104
Checking an older 6 volt coil
Six volt systems on Willys-era vehicles run at lower voltage than modern ignitions, so a coil that is weak or open often causes hard starting or a dead cylinder under load. Before fitting a new coil, check the battery, the connections and the ground strap, since a poor ground can look like a coil fault.
Points-type ignitions usually need attention at the same time. Check point gap, contact faces and the condenser, because worn points can cause weak spark that resembles a failing coil. Keep the coil tower clean and dry, and make sure the primary wire is tight at the terminal.
- Test battery voltage and ground before replacing the coil
- Inspect points, condenser and rotor contacts together
- Use dielectric grease on the tower connection when assembling
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0649712 |
| UPC | 848399053104 |
| Component | Ignition coil |
| Voltage | 6 volt |
| Fitment type | Direct fit |
| Type | Stock replacement |
Vehicle fitment
It fits 1941 to 1958 Jeep Willys models, including 1-Ton, 463, 473, Base, CJ-2, CJ-3 (Chassis), CJ-5, CJ-6, DJ-3, FJ, Jeepster, Panel, Sedan Delivery, Truck, Utility Wagon and MB Willys models.
Jeep Wrangler, Cherokee and later models are not covered. Confirm fit for your year, model and trim before ordering.
What’s included
The product is the ignition coil only, and no included hardware is named.
Not included: This part is the coil only. Check your ignition wires, distributor cap and rotor against your installation before starting.









